ADT® Authorized Dealer Serving Entire Champaign-Urbana Metro Area
close up of a lady adjusting the security panel
March 01, 2022

How To Reset Your Champaign System

An important advantage of having your security system hooked up by trained experts is that you seldom have to worry about it. Even so, there may be times where you must reset your alarms in Champaign. If you use the ADT Command interface, resetting typically requires just a few minor tap of a button when you’ve experienced occurrences like battery changes, power outages, and false alarms.

Read The Owner’s Manual Before Resetting Your Alarm

One note of caution before you start resetting your Champaign home security system, read your manual ahead of time. You’ll never want to damage your property’s defense because you hit the wrong button. In addition, the process could have changed if you switched from a number pad to a fully digital system. Keep in mind that if you’re struggling to reset your system, don't be reluctant to reach out to the professionals.

Resetting Your Champaign Security System Because Of A False Alarm

Usually, a false alarm happens as a result of the accidental tripping of a sensor. You can use the ADT Command touchscreen or open your ADT security app and hit the shield image and type in your security code to turn off the system when this occurs. You could be contacted by your monitoring professionals, but simply inform them that you had a false alarm.

How To Reset Your Alarm After A Power Outage In Champaign

When you lose power from high winds or other factors, you could start hearing a steady beep from your alarm’s central interface. This signifies that your security is running off the battery backup. To reset your equipment and stop the steady beeps, you must deactivate and reactivate your system.

But please note, if your power outage lasts for a longer period of time, you might need a full system reset. Pay careful attention to the directions in the manual -- typically by entering your unique passcode and pressing the on/off button twice -- and you should be back to normal. You may still hear chirping caused by the secondary power source, as it’s possible it won’t end until your battery is fully charged. Call your security technician if you continue to have problems with your ADT system 20 hours after your power is back on.

How To Reset Your Home Security System After Switching Out A Battery

There will be infrequent times when you need to switch out a battery powering one of the devices in your security installation. In order to accomplish this, you should switch your alarm system to test mode so you don't trigger a false alarm. When the battery is replaced, move the system from Test Mode and resume your usual settings. If the command center doesn't recognize the component or the battery indicator is still on, you may have to perform a total reset of the system.

Resetting Your Champaign Security System When Adding Or Removing A Code

The addition and deletion of people can be accomplished on your ADT Command hub and your ADT mobile app. You shouldn't require a system reset following the addition or deletion of users. However, if you move into a new house that already has an ADT system, you need to contact your security specialists at (217) 765-0086 to establish a new contract. The installer will go on site to switch out outdated parts, install other devices (if necessary), and perform a full reset.

A User-Friendly Security System Is The Right Choice

Attempting to reset a home security system in Champaign can be frustrating if it fails to include understandable equipment and instructions. If you would like to get your functional and powerful home protection system, call (217) 765-0086 or send in the form below. Our specialists are pleased to design the right security system for your residence.